Hornady 366 Parts Diagram Official
The 366 had simply stopped feeling right . The stroke was spongy. The index pawl hesitated. A single #209 primer had failed to seat yesterday, crushed sideways in its pocket like a tiny, silver pancake. That one misfeed meant distrust. And in reloading, distrust meant you pulled the handle again, slower, listening.
Tomorrow he would load five hundred rounds of .45 ACP. Tonight, he had rebuilt a machine by reading its confession.
That was the difference between a shooter and a reloader. A shooter saw a tool. A reloader saw a system.
Arthur wiped the diagram clean of graphite smudges and refolded it along its ancient creases. He slid it back into the manual’s pocket. The 366 wasn’t just a reloading press anymore. It was a map of decisions—Hornady’s engineers on one side, his own repairs on the other. And between them, the trust that came from knowing exactly where every spring, pin, and punch lived. hornady 366 parts diagram
It wasn’t broken. That was the problem.
“That’s you,” Arthur whispered to the machine. “Bent stem or a tired spring.”
He reassembled the 366 by the diagram’s reverse order. Lower tier, then upper. Cam followers greased. Pawl timed to the shell plate’s detent. When he finished, he dropped a primed case into station one and pulled the handle. The 366 had simply stopped feeling right
He didn’t have a replacement. But the diagram reminded him of something: part #44, the Seater Punch Return Spring. If the spring was weak, the punch would drag. He replaced it with a spring from his spares jar—a generic coil that was 0.002 inches thicker.
He pulled the diagram closer. Under the lamp, the paper had yellowed at the folds. He’d drawn his own notes in the margins over the years: “#27—replace every 5k rounds,” and “#63 (detent ball) WILL fly across room. Use magnet.” The diagram was no longer Hornady’s document. It was Arthur’s diary.
The parts list was not merely an instruction. It was a confession. Folded into the back of the manual, the exploded view showed the 366 as no human had ever seen it: disassembled, weightless, each component suspended in its own halo of white space. The main shaft (#7) ran like a spine through the ghost of the cast iron frame. Around it clustered the cams, the wedges, the wiper arms. A single #209 primer had failed to seat
He traced the primer system first. There it was: the Primer Slide (#39), a tiny steel boat that ferried primers from the drop tube to the seating punch. Next to it, the Primer Slide Spring (#40)—a fragile coil no bigger than his pinky. That , he thought. That’s the liar.
The stroke was crisp. The index was sharp. The primer seated with a sound like a cork popping.
His gaze settled on the part he’d never needed: the Primer Seater Punch (#43). In the diagram, it looked like a tiny mushroom—a flat face on a steel stem. But the callout box added a warning: “Seater depth adjustable via locknut. Do not overcam.” Arthur had read that note fifty times. Tonight, he realized what it meant. The 366 didn’t have sensors or computers. It had geometry. The punch’s travel was governed by a cam slot in the main shaft. If you over-cammed—if you forced the handle past its natural stop—you didn’t just crush a primer. You bent the punch stem. And a bent stem didn’t show on the outside. It showed in the feel, a year later.
So Arthur did what he always did when a machine lied to him. He reached for the diagram.
